![]() ![]() It would be extremely useful for modelling of structural framing to be able to specify whether generated beams and columns should have joins enabled or disabled by default upon the element creation - instead of leaving this entirely up to the component to interpret. Since the update, this routine has broken because joined elements cannot have their z Justification parameter modified. For example, previously i had setup a routine to set member end length offsets, insertion points, and member rotations based on parameters contained in a finite element model using the Element Parameter component. In release, a change was made that automatically enables joins if the element family is ‘structural framing’ - previously my experience was that all beams and columns brought into revit by rhino inside had joins disabled by default.Įnabling/disabling joins seems to have an impact on what element parameters are allowed and not allowed to be modified. So this post is with regards to modelling structural steel framing (beams, columns, braces). I have been using Rhino Inside Revit as a mechanism for converting finite element structural models into Revit models.
0 Comments
Leave a Reply. |